Hot-Melts for Low-Pressure Molding
September 2008
 Print this page

A provider of adhesives and specialty chemicals will showcase technologies from leading suppliers at the 2008 Advanced Technologies Expo, September 23–25. Among them is Henkel’s Macromelt OM 6 series, specially modified thermoplastic polyamide hot melts made especially for low-pressure molding. Produced from renewable raw materials, the Macromelt products melt and flow at low viscosities (1000 to 10,000 cP), suitable for the low injection pressure process. They offer good adhesion to various substrates, including PVC, PA6.6, PUR, and PP, and bond to form a watertight and chemical seal.

0


Canon Communications LLC . © 2008