OPEI Issues Tamper-Resistance Compliance Guidelines
Sep 26, 2011
 Print this page

The Outdoor Power Equipment Institute (OPEI) issued a new Guidance Document outlining best practices and guidelines on tamper-resistance compliance for small engines and lawn and garden products.

Over the past year, the U.S. Environmental Protection Agency (EPA) initiated enforcement actions that led to the seizure of small engines and lawn and garden products because of concerns that the engines were equipped with carburetors that could be illegally adjusted by repair facilities and consumers. Such illegal tampering could potentially cause emissions in excess of the engine’s EPA-certified configuration. In these cases, EPA determined that the carburetors were equipped with inadequate tamper-resistant features.

To prevent such illegal tampering and adjustments, carburetors typically have limiter caps or seals that prevent adjustments outside of the certified configuration. In some products, adjustments can only be made using special tools exclusively supplied by a manufacturer to their repair networks and dealers.

OPEI hopes to improve the current process with the Guidance Document on Tamper-Resistance Compliance. “OPEI urges all the affected carburetor and engine manufacturers and importers to closely review and promptly adopt the suggested best practices in the OPEI Guidance,” said Kris Kiser, president and CEO of OPEI.

The Guidance recommends the following:
• Carburetor or engine manufacturers should first obtain pre-approval by the California Air Resources Board (CARB), which tests each carburetor to ensure that its tamper-resistant mechanisms are compliant.
• CARB pre-approval - along with detailed descriptions and pictures of the tamper-resistant mechanism or device and the manufacturer’s special tools - should be submitted electronically to the U.S. EPA Certification Office as part of engine certification applications for the upcoming 2012 and subsequent model year engines.

“As long as this documentation is submitted to EPA and the tamper-resistant mechanisms have been produced and installed as approved by CARB, then manufacturers should be able to manufacture and/or import engines and products without market disruption,” stated OPEI Counsel, Bill Guerry.

In those circumstances where CARB has not tested or approved the carburetor, manufacturers should submit documentation to EPA on their own tamper-resistant testing results (pursuant to OPEI Guidance) demonstrating satisfactory tamper resistance.

OPEI expects EPA to issue its own enforcement alert and certification guidance this fall that will provide clarifications that are similar to the OPEI Guidance Document.

The OPEI Guidance can be downloaded at:

Back to Breaking News